![]() ![]() GPS out enabled, tick if you use NTP synch and then use GPS out to secondary node. Support system control, tick if WCDMA is the primary node.Ībsolute time synch enabled, tick if you use GPS for synch. RBS6201V2W or RBS6102W or other RBS type. The following examples are from configuration MMR-A for RBS906-W1. rbsiov/CXP9018436_R2N01/CXP9018436%1_R2N01.xmlĥ.1Ĝabinet Equipment Configuration WizardĬlick Tools -> Cabinet Equipment Configurationįollow the wizard and fill in correct info for your configuration. (To install BEM, see 8.1 Install Element Manager on Unix account)Īdd your RBS and click connect. ![]() Maybe you need to upgrade the node to a later SW than BasicCV before you start the configuration. (The above is only one command, not one for each row) Load Basic CV for W10B DUW GA (based on UP CXP9016868_R3AF11): Optional, save a backup of the file storing ip address: Set the IP address for the site LAN connection (LMTB port) The workstation environment should be prepared with correct project and config_spec.Ĭonnect to DUW with serial connection (LMTA port): It is assumed that configuration is made using unix environment in PDU RBS lab. This guide is written to be used by testers with non-WCMDA background when configuring WCDMA nodes in MSMM project. PA4 ĞKAMARI Updated ch 9.2.1 with moshell connection to RNC directly from unix. ![]() PA3 ĞKAMARI Updated ch 5.2 with a static route for the OSS connection and ch 6 with a new license key file valid until 2012-06. User manual for configure WCDMA RBS in PDU RBS labĥ.1Ĝabinet Equipment Configuration WizardĖĥ.3 Site Equipment Configuration Wizardđ9ħ.1.1 Set system constant 412 inhibitOptimalPaBiasLevelē5ĩ.1 Install Element Manager on Unix accountē6ĩ.2.2Ĝonnect to RNC using xterm in unixē7 ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
January 2023
Categories |